Vivotek IP2112 Spezifikationen PDF herunterladen (Seite 16)

First access to Network Camera

Change initial password of administrator

Starting the Web browser to connect to the assigned IP address of Network Camera,

users will be asked for user name and password by an authentication message window.

A root password, identical to the Network Camera's serial number, is needed for the

initial access to a newly installed Network Camera. The administrator must change the

root password immediately after the initial installation to ensure security. The new root

password should be well memorized since there is no way to retrieve or recover it. After

changing the password, the browser will display an authentication window again to ask

for the new password. If the root password is deleted as blank, the authentication

mechanism will be disabled.

Manage user privilege

For complete protection from illegal usage, Network Camera provides three privileges

and always needs user name and password before access. The lowest level is DEMO

mode whose services are subject to administrator's permission. The standard level is the

USER mode that consists of twenty user profiles. Each user is able to access Network

Camera under the given privilege, except for system configuration. The twenty user

profiles are also maintained by the administrator. The highest level is ROOT mode that

only opens to administrators for initial setup, system configuration, user administration

and software upgrade. The user name of the administrator is internally assigned to

“root”.

Complete the network settings

Although Network Camera already can be accessed after software installation in local

area network, administrators should complete the network settings in the configuration

page. The complete network configurations including subnet mask as well as the IP

address of default gateway and DNS are provided by your network administrator or

Internet service provider. Once the wrong network settings make Network Camera fail to

work, refer to Appendix A to restore factory default settings.

By default Network Camera will need administrator's installation every time it reboots. If

the network settings are sure to work all the time, disable the install option in network

configuration Web page or Installer program.

Details about configurations are described in the relative category of the Chapter

Definitions of Configuration

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 68 69

Keine Kommentare

Vivotek IP2112 Spezifikationen Seite 16