Vivotek FD8134 Installationsanleitung

Quick Installation GuideEnglish繁中 日本語Español Português簡中FrançaisDeutschItalianoTürkçePolskiРусскийČesky SvenskaVIVOTEK INC.6F, No.192, Lien-Cheng Rd.,

EN - 9EnglishFor further setup, please refer to the user's manual on the software CD.Ready to Use 61. Access the Network Camera on the LAN.2. Ret

EN - 10Based on the live image retrieved from the camera, adjust the camera lens to the desired viewing angle:1. Turn the lens module left and right.

EN - 11English1. Align the inner side of the black cover with the notch on both sides of the lens, x the black cover.2. If you choose to the feed t

Quick Installation GuideEnglish繁中 日本語Español Português簡中FrançaisDeutschItalianoTürkçePolskiРусскийČesky SvenskaVIVOTEK INC.6F, No.192, Lien-Cheng Rd.,

EN - 1EnglishPower off the Network Camera as soon as smoke or unusual odors are detected.Contact your distributor in the event of occurrence.Keep the

EN - 2Do not place the Network Camera on unsteady surfaces.Do not touch the Network Camera during a lightning storm.Do not disassemble the Network Cam

EN - 3EnglishSoftware CDFD8133 or FD8134Alignment StickerDrill holeDrill holeCable holeRJ45 Female/Female Coupler / Screws / Clamp CorePower Adapter50

EN - 4First, follow the instructions below to remove the dome cover.Hardware Installation3Physical Description2Dome CoverLensIR LEDs (8 units, distanc

EN - 5EnglishAA1. Attach the alignment sticker to the ceilling/wall.2. Through the two circles on the sticker, drill two pilot holes into the ceilling

EN - 6General Connection (without PoE)Network Deployment4+ : Digital input- : Digital inputPOWERCOLLISIONLINKRECEIVEPARTITION1234523Ethernet Switch11

EN - 7EnglishPOWERCOLLISIONLINKRECEIVEPARTITION12345Power over Ethernet (PoE) (FD8134 only)POWERCOLLISIONLINKRECEIVEPARTITION12345PoE SwitchWhen using

EN - 8Network CameraModel No: FD8134Made in TaiwanThis device complies with part 15 of the FCC rules. Operation is subject to the following two condit