Vivotek CC8130 Installationsanleitung PDF herunterladen (Seite 5)

EN - 4

Strain relief boot

Mounting the Network Camera - Desktop or Wall Mount

1. You can install the camera to a desktop or to a wall by driving screws through the holes shown

below.

2. Flip the hang ring to the top. You may also secure a camera to wall using the hang rings.

3. Install camera by sliding it down against the bracket. Make sure the RJ-45 connector is properly

mated.

IMPORTANT:

Record the MAC address before installing

the camera.

NOTE:

It is recommended to use an Ethernet cable that

comes without the strain relief boot. You can remove

the boot if your cable comes with one.

4. Secure the installation by driving a pan head screw through

the hang ring and to the bracket behind.

NOTE:

To detach a camera, remove the retention screw from

the top and from the bottom, and insert a straightened

paperclip into the release button to press on the RJ-45

locking tab.

1 2 3 4 5 6 7 8

Keine Kommentare

Vivotek CC8130 Installationsanleitung Seite 5