Vivotek IP3136 Installationsanleitung Seite 49
- Seite / 65
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
- 47 -
www.vivotek.com
Appendix
A. Troubleshooting
Status LED
After powering up, the Network Camera performs a self-diagnostic to detect any
hardware defects. The following table lists the LED patterns in general. In case of any
fatal error, the LED will blink in a pattern other than those below.
Condition LED color
During self-diagnostic after power on Blink in interchanged green and red
Ethernet signal is lost Steady red till Ethernet is detected
Before network is setup Steady green till IP address is confirmed
After network is setup Blink green every second
Network is setup and audio is disabled Blink green every 4 seconds
Any hardware failure Other patterns
Reset and restore
There is a button in the back of the Network Camera. It is used to
reset the system or restore the factory default settings.
Sometimes resetting the system sets the system back to normal
state. If the system problems remain after reset, restore the
factory settings and install again.
RESET: Click on the button.
RESTORE: 1. Press on the button continuously.
2. Wait for self-diagnostic to run twice.
3. Free the button as soon as the second self-diagnostic starts.
Restoring the factory defaults will erase any previous settings. Reset or restore the
system after power on.
- Before You Use This Product 3
- Table of Contents 4
- Package Contents 7
- Installation 8
- Software installation 9
- Check Network Settings 10
- How to Use 11
- Installing plug-in 12
- Primary user’s capability 13
- Digital Zoom 14
- Snapshot 15
- Client settings 15
- Administrator’s capability 18
- Only Quality Images Will Do 19
- Change homepage layout 21
- How to change the font color 22
- How to change the background 22
- Build a security application 31
- Software revision upgrade 32
- Definitions in Configuration 33
- System parameters 34
- Security settings 35
- Network settings 36
- WLAN Configuration 37
- Mail & FTP 39
- DDNS and UPnP settings 41
- Video codec parameters 41
- Motion detection 44
- Application settings 45
- Homepage layout settings 47
- Viewing system log 48
- Viewing system parameters 48
- Factory default 48
- Appendix 49
- Restart system 53
- Page URL 54
- System resource URL 54
- System configuration URL 55
- Security configuration URL 56
- Network configuration URL 56
- Video configuration URL 60
- D. Technical specifications 64
Verwandte Produkte und Handbücher für Sicherheitskameras Vivotek IP3136
Sicherheitskameras Vivotek IP8162 Spezifikationen
(199 Seiten)
(199 Seiten)
(2 Seiten)
(68 Seiten)
Sicherheitskameras Vivotek VS8102 Spezifikationen
(156 Seiten)
(156 Seiten)
Sicherheitskameras Vivotek IP8151P Spezifikationen
(179 Seiten)
(179 Seiten)
(9 Seiten)Sylvania SST4274 manuales
Manuales del propietario y guías del usuario para Televisores Sylvania SST4274.
Ofrecemos 1 manuales en pdf Sylvania SST4274 para descargar gratis por tipos de documentos: Manual de usuario
Kommentare zu diesen Handbüchern